”This hydraulic motor is well used, why is it getting louder? I haven’t done anything yet?” Said Mr. Li who repaired the hydraulic motor. “The sound is too loud and noisy operators can’t work normally What should I do with the noise of the hydraulic motor? “Facing Mr. Li who was questioning, we only responded with a wry smile. There are many reasons for the noise of the hydraulic motor, and Ottos sorted out some common situations, as follows:
Hydraulic motor repair failure type
Causes of high noise of hydraulic motor:
①The seal is not strict, and air invades inside
②The hydraulic oil is contaminated, there are people with bubbles
③The oil temperature is too high or too low
④The coaxiality of the coupling is out of tolerance
⑤ Excessive hydraulic oil drill
⑥ The radial size of the hydraulic motor is seriously worn
⑦The blade is worn
⑧Poor contact between the blade and the stator, there is a collision phenomenon
⑨ Stator wear
How to eliminate the noise of hydraulic motor:
①Check the seal of the relevant parts and tighten the connection points
②Replace clean hydraulic oil
③Check the working status of temperature control components
④Correction coaxiality
⑤ Change the oil with less cat degree
⑥ Grinding cylinder hole, readjusting plunger
⑦ Repair or replace as much as possible
⑧ Perform trimming
⑨ Repair or replace. If the abrasion is increased due to excessive spring rigidity, the spring with lower rigidity
Post time: Jun-24-2020